Díaz-Mena, Víctorde Prado, J.Roldán, M.Izaguirre, I.Sánchez, M.Rieth, M.Ureña, A.2024-04-042024-04-042023V. Díaz-Mena, J. de Prado, M. Roldán, I. Izaguirre, M. Sánchez, M. Rieth, A. Ureña, Numerical and experimental development of cupronickel filler brazed joints for divertor and first wall components in DEMO fusion reactor, Journal of Nuclear Materials, Volume 588, 2024, 154830, ISSN 0022-3115, https://doi.org/10.1016/j.jnucmat.2023.1548301873-4820https://hdl.handle.net/10115/31988This work has been carried out within the framework of the EURO-Fusion Consortium, funded by the European Union via the Euratom Research and Training Programme (Grant Agreement No. 101052200 — EUROfusion). Views and opinions expressed are however those of the author(s) only and do not necessarily reflect those of the European Union or the European Commission. Neither the European Union nor the European Commission can be held responsible for them. The authors acknowledge the use of instrumentation and the technical advice provided by the Facility ICTS, node “Laboratorio de Microscopías y Análisis de Superficie” at the CIEMAT.The brazeability of a cupronickel commercial alloy (Cu10Ni) was evaluated for its use as a filler alloy for high-temperature joining of tungsten to the reduced activation ferritic/martensitic steel EUROFER 97 (W-E) and between tungsten base materials (W-W) for its application at the first wall and divertor of future fusion reactors. In addition, given the importance of the residual stresses in these heterogenous joints, a study of the brazing conditions and the impact of the selected filler has been conducted using numerical software to understand its impact on the quality of the joint. Two thermal cycles were evaluated (1165 °C and 1190 °C) and selected based on the thermal characterization of the filler alloy. The microstructural examination revealed that, in W-E joints, nickel acts as an activator element, reacting and forming interfacial layers at the EUROFER 97 - Cu10Ni interface. In the case of the W-W joints, a lower level of diffusion phenomenon and metallurgical interaction between Cu10Ni and base materials were observed. The hardness profile indicated that the hardening process of EUROFER 97 was associated with the formation of untempered martensite. On the other hand, tungsten kept the received hardness. The mechanical characterization by shear test reported similar values between both types of joints carried out at 1190 °C but different when the temperature was increased (1165 °C), associated with the brittle character of tungsten and its lower metallurgical interaction. The numerical analysis of the brazing process carried out with ANSYS software shows that residual stresses are accumulated mainly at the interfaces. The information provided by the simulation shows, for a 50 µm filler thickness, the importance of mitigating the residual stress by selecting a filler with an intermediate Coefficient of Thermal Expansion (CTE) that alleviates mechanical stresses relative to the base materials.engAtribución 4.0 Internacionalhttp://creativecommons.org/licenses/by/4.0/BrazingFusion reactorTungstenEUROFER 97ANSYSinfo:eu-repo/semantics/article10.1016/j.jnucmat.2023.154830info:eu-repo/semantics/openAccess