Examinando por Autor "Bonache, V."

Mostrando 1 - 2 de 2

Exploring W-EUROFER brazed joints: S/TEM and nanoindentation analysis following post-brazing tempering treatment
(Elsevier, 2025-01) Izaguirre, I.; Roldán, M.; Prado, J. de; Bonache, V.; Sánchez, M.; Ureña, A.
Tempering treatments are essential for restoring the hardness and microstructure of EUROFER steel when W-EUROFER joints are formed at temperatures exceeding the steel's austenitization point (890 °C). This post-brazing heat treatment can, however, alter the microstructure and thereby affect the mechanical properties. This study explores the microstructural and nanomechanical effects in the brazed area of W-EUROFER joints following this heat treatment, utilizing copper as an intermediate filler material. Using Scanning Transmission Electron Microscopy (STEM) with Energy Dispersive Spectroscopy (EDS) on FIB lamellae and nanoindentation techniques we examined the stability and phase characteristics of the post-tempered microstructure in two lamellae that covers the whole phases of the braze microstructure. The tempering process enhances copper diffusion and the growth of copper precipitates without significantly altering the joint's overall microstructure. Despite the general stress-relief effects of tempering, which typically lower mechanical properties, the diffusion phases formed during brazing maintained high hardness and modulus, indicative of a complex, element-rich composition. A reduction in mechanical properties was observed in the iron-rich phase near the W-braze interface and the EUROFER base material, aligning with the purpose of the heat treatment. However, the copper braze and tungsten base material largely retained their stability and resilience to thermal treatments. This research provides vital insights into the behavior of these material systems under thermal processing, highlighting the necessity of optimizing heat treatment parameters to preserve joint integrity in high-performance applications such as nuclear fusion reactors. The findings contribute significantly to the development of durable and reliable materials for fusion energy, emphasizing the importance of controlled tempering processes to enhance material properties
Ti6Al4V/SiC Metal Matrix Composites Additively Manufactured by Direct Laser Deposition
(Springer, 2022) Sánchez de Rojas Candela, C.; Riquelme, A.; Bonache, V.; Rodrigo, P.; Rams, J.
Nowadays, research on additive manufacturing of Ti6Al4V alloy is growing exponentially but there are just a few studies about additive manufacturing of metal matrix composite components. In this work, highly reinforced Ti6Al4V matrix composites with SiC particles have been additively manufactured by direct laser deposition (DLD). Ti6Al4V powder and SiC particles have been deposited layer by layer to form an additive thin wall structure. The geometry, microstructure, and microhardness of the samples are strongly infuenced by the laser scanning speed used during de fabrication process. In addition, the efect of the SiC increment in reinforcement concentrations and the infuence of SiC particle sizes in the microstructure have been evaluated, and the reaction mechanisms have been established. The percentage of reinforcement measured is lower than expected due to the reinforcement-matrix reactivity that results in partially dissolved SiC particles and the formation of a TiC and Si5Ti3 ring around them. The size and number of particles and reaction products depend on the initial size and percentage of reinforcement and the DLD scanning speed. The higher the size and percentage of SiC particles and reaction products in the matrix, the higher the hardening efect of the composite matrix.