Examinando por Autor "Molina, Raul"

Mostrando 1 - 4 de 4

Application of a Fenton process for the pretreatment of an iron-containing oily sludge: A sustainable management for refinery wastes
(Elsevier, 2021-12-03) Jerez, Sara; Ventura, Maria; Molina, Raul; Martínez, Fernando; Pariente, Maria Isabel; Melero, Juan Antonio
The feasibility of a Fenton-type process for the pretreatment of an oily refinery sludge has been explored taking advantage of the iron contained in the own sludge. This process reduces the content of total petroleum hydro-carbons (TPHs) accompanied by an increase in the total organic carbon concentration in the liquid phase. The effect of the temperature and the hydrogen peroxide loading was thoroughly studied in this work being the oxidant concentration the most critical parameter. Under 60 ◦C and 90 g/L of initial hydrogen peroxide concentration, the Total Organic Carbon (TOC) of the liquid phase was increased up values of 1336 mg/L and with a remarkable contribution of acetic acid as final oxidized compound (396 mgC/L). Additionally, nitrogen and phosphorous compounds were also dissolved in the aqueous phase achieving values of 250 mg/L and 7 mg/L for total Kjeldahl nitrogen and total phosphorous, respectively. Respirometry assays of the aqueous phase after the Fenton pretreatment have evidenced an increase of biodegradability up to 49% which makes this phase suitable for further biological processing in the refinery scheme. The reduction of the content of TPHs (61%) of the oily sludge, has also improved the settleability of the treated effluent (reducing the capillary suction time (CST) in ca. 88%).
Hydrogen production by water splitting with Mn3-xCoxO4 mixed oxides thermochemical cycles: A thermodynamic analysis
(Elsevier, 2020-07-15) Orfila, Maria; Linares, Maria; Molina, Raul; Marugan, Javier; Botas, Juan Angel; Sanz, Raul
The high temperature required for hydrogen production by solar driven thermochemical cycles is a critical factor hindering full-scale applications. The thermochemical cycle based on Mn3O4/MnO redox pair is one of the most studied despite the high operating temperature required for complete de reduction step (1623–1723 K). The combination of Mn3O4 with Co3O4, a metal oxide with lower reduction temperature than Mn3O4 that cannot be used for hydrogen production due to thermodynamic limitations, is presented as a way to decrease significantly the energy demand of the cycle. In this work, a complete thermodynamic study of thermochemical cycles with different Mn/Co mixed oxides (Mn3-xCoxO4, 0.9 < x < 2.7) for hydrogen production has been performed. The study of the variation of Gibbs energy with temperature allowed to determine that the thermal reduction of the metal oxide (Mn3-xCoxO4) takes place at temperatures between 1048 and 1173 K, which can be achieved by conventional solar concentration technologies. Unfortunately, the oxidation of the reduced metal oxide (Mn3-xCoxO3) with water to produce H2 is not feasible from a thermodynamically point of view, so a stronger oxidizing agent, as sodium hydroxide, is required. The optimum temperature for the oxidation with NaOH was found to be 1373 K, meaning that this reaction takes place at higher temperatures than those actually required for the reduction, something uncommon in thermochemical cycles for water splitting. On the other hand, after the study of the variables affecting the equilibrium like the inert gas/solid ratio, it can be concluded that in both reactions, thermal requirements can be reduced by operating at lower temperatures by means of a higher inert gas/Mn3-xCoxO4 ratio. Finally, energy and exergy analysis of the system based on the solar absorption efficiency and the energy requirements predicts a solar-to-fuel efficiency and exergy efficiency of 40% and 23%, respectively. These values are comparable or even higher than those found in literature for other metal oxides thermochemical cycles for water splitting, thus with the advantage of working at a considerable lower temperature (1373 K).
Nanocomposite of crystalline Fe2O3 and CuO particles and mesostructured SBA-15 silica as an active catalyst for wet peroxide oxidation processes
(ELSEVIER, 2006) Melero, Juan A.; Calleja, Guillermo; Martinez, Fernando; Molina, Raul
Crystalline Fe2O3 and CuO particles have been incorporated into surfactant-templated SBA-15 materials by direct synthesis. Activity and stability of this material were evaluated on the wet peroxide oxidation of phenol under mild reaction conditions. Its catalytic performance was monitored in terms of total organic carbon (TOC) conversion. The stability was determined by careful measurements of metal leaching into the aqueous solution. The presence of copper prevents the leaching of iron species and increases TOC degradation as compared with those materials containing only crystalline Fe2O3 particles. Moreover, the treatment of iron-copper composite materials under controlled acidic conditions in the presence of hydrogen peroxide leads to the stabilization of metallic species, maintaining TOC degradation rates similar to the fresh catalyst. Thus, this work introduces a new material with interesting properties as Fenton-like catalysts in advanced oxidation processes for pollutant abatement in wastewaters.
Thermochemical Energy Storage Using the Phase Transitions Brownmillerite-2H Perovskite - Cubic Perovskite in the CaxSr1-xCoO3-δ (x=0 and 0.5) System
(American Chemical Association, 2021-08-09) Azcondo, Maria Teresa; Orfila, Maria; Linares, Maria; Molina, Raul; Marugan, Javier; Amador, Ulises; Boulahya, Khalid; Botas, Juan Angel; Sanz, Raul
The oxides Ca0.5Sr0.5CoO3−δ and SrCoO3−δ, which present perovskite or perovskite-related phases in different temperature domains, have been tested as materials for thermochemical energy storage. The first one, Ca0.5Sr0.5CoO3−δ, experiences a reversible phase transition upon consecutive cycles under an airflow at a maximum operating temperature of 1196 K. Unfortunately, the heat stored in this process, associated with an oxygen loss/gain and a structural phase transition, is very small, hindering its use for thermochemical heat storage. The as-prepared oxide SrCoO3−δ, which displays a brownmillerite structure like the Ca-containing compound, in the first heating step irreversibly segregates some Co3O4 at 823 K to yield a 2H hexagonal perovskite. This phase reversibly transforms at 1073 K into a cubic perovskite. These 2H ⇄ C transitions occur from the 2nd to, at least, 30th cycle. The average absorbed and released heat is ∼104.1 ± 0.06 and ∼68.8 ± 1.8 J/g, respectively, and therefore, SrCoO3−δ presents a high exo/endo ratio. The exergy efficiency is, on average for the 30 cycles performed, as high as 63.9 ± 1.2%. The mechanism of the phase 2H ⇄ C transition of SrCoO3−δ explains the good performance of this material for thermochemical energy storage.