Examinando por Autor "Satuf, M. Lucila"

Mostrando 1 - 2 de 2

Kinetic modelling of Escherichia coli inactivation in a photocatalytic wall reactor
(Elsevier, 2014) Marugán, Javier; Grieken, Rafael van; Pablos, Cristina; Satuf, M. Lucila; Cassano, Alberto E.; Alfano, Orlando M.
A kinetic model of the photocatalytic inactivation of Escherichia coli in an annular wall reactor is presented. The model is based on a reaction scheme that involves a series of events in which bacteria are progressively damaged and eventually led to cell lysis. The model explicitly takes into account radiation absorption effects. Photocatalytic inactivation experiments were carried out in a photoreactor operated in a closed recirculating circuit with a reservoir tank and irradiated with a 6W black light lamp situated in the axis of the reactor. Immobilization of TiO2 Aeroxide P25 has been carried out by the dip-coating procedure onto the inner-tube wall of the annular reactor. Experimental results for different TiO2 layer thicknesses were used to estimate the kinetic parameters of the model. Good agreement between model predictions and inactivation experiments was achieved in the whole range of TiO2 thicknesses studied.
Rigorous kinetic modelling with explicit radiation absorption effects of the photocatalytic inactivation of bacteria in water using suspended titanium dioxide
(ELSEVIER, 2011) Marugán, Javier; van Grieken, Rafael; Pablos, Cristina; Satuf, M. Lucila; Cassano, Alberto E.; Alfano, Orlando M.
This study is focused on the kinetic modelling of the photocatalytic inactivation of bacteria with suspended TiO2. A rigorous model based on a proposed reaction mechanism and accounting explicitly for the rate of photon absorption has been developed. The application of the general kinetic expression to limiting cases suggests that the interaction bacteria-catalyst can be considered to be weak. In contrast, a complex dependence on the radiation absorption rate must be taken into account, as very different radiation conditions may coexist inside the photoreactor, with high absorption rates in the region near to the radiation entrance window and much lower values on the opposite side of the photoreactor. The model has been successfully validated by experimental data, being able to reproduce the evolution of the concentration of viable bacteria in a wide range of values of TiO2 concentration, irradiation power and initial concentration of bacteria with a normalized root mean square logarithmic error of 5.3 %. The values of the kinetic parameters are independent of the specific reactor setup or the operating conditions and therefore, the model can be used in a predictive way for photoreactor design and scaling-up, as well as for the optimization of other reactor configurations.