Carrying Gas Influence and Fabrication Parameters Impact in 3D Manufacturing of In Situ TiN-Ti Composites by Direct Laser Deposition
Zusammenfassung
The difculty of getting a correct distribution of the reinforcement in the metal matrix and the complexity for achieving a good-metallurgy matrix-reinforcement bonding has limited the development of additive manufacturing of metal matrix composites. This research proposes the use of a reactive atmosphere during the fabrication process to obtain titanium matrix composites reinforced with TiN. The relation between the carrying gas and the process parameters used with the presence of porous and defects, the microstructure, and microhardness has been obtained. Nitrogen was used as the carrying gas of the titanium powder. Under laser irradiation, the particles melt and react with nitrogen, resulting in the formation of a titanium matrix composite highly reinforced with TiN. The composite obtained had a microhardness increase between 50 and 100% in comparison with titanium samples fabricated in the same conditions in an argon atmosphere. Three reaction mechanisms have been proposed to take place in the microstructure, depending on the amount of nitrogen in the titanium particles, and its difusion in them during the manufacture.
Beschreibung
Acknowledgements This work was supported by Comunidad de Madrid (ADITIMAT-CM S2018/NMT-4411) and ADITINANO (2020/00007/019). Funding Open Access funding provided thanks to the CRUE-CSIC agreement with Springer Nature. Authors reports financial support was provided by Universidad Rey Juan Carlos and Comunidad de Madrid.
Colecciones
- Artículos de Revista [4166]